autocad
19-07-2005, 03:06 PM
I'm stuck!
I am putting a 2.0 agg in to the truck and cannot find a throttle body. i cant use the original as i am using a MK2 digi loom,
I have a Bosch throttle body but it has no air bypass screw or throttle stop. Without the by pass will the engine run or be tuneable tickover etc..? Assuming the Idle stabilisation valve allows enough air into the engine for it to tick over?
The body is much bigger than the standard, If i put the bigger body on the engine will the engine just bog when i open the throttle.
Is the there a better throttle to use???
I am putting a 2.0 agg in to the truck and cannot find a throttle body. i cant use the original as i am using a MK2 digi loom,
I have a Bosch throttle body but it has no air bypass screw or throttle stop. Without the by pass will the engine run or be tuneable tickover etc..? Assuming the Idle stabilisation valve allows enough air into the engine for it to tick over?
The body is much bigger than the standard, If i put the bigger body on the engine will the engine just bog when i open the throttle.
Is the there a better throttle to use???